The Slave Driver is so much more than a 1 watt practice/recording head. Driven by a single 12AU7 and a single 12AY7 preamp section the Onkel 1w can be used as a 1w practice/recording head with passive FX loop. The send can be used as a preamp out allowing you to add vintage tube tone to any amp or you can go directly to the board for live gigs or recording. Line out in rear can be switched between instrument level and line level, and can be used for recording or live gigs. The line out adds the entire circuit post OT and can even be run in a pedal chain. Built in dummy load so no speaker is required for operation. You can even use the 1w power section, the preamp out, and the line out simultaneously. And it's all in a custom solid wood enclosure measuring 12"x 6.5"x 7.5".
-solid state rectifier
-12AY7 preamp tube
-12AU7 bridged power tube
-passive FX loop
-8 ohm speaker output
-Line out switchable from line level to instrument level
-bright switch
Built using quality components such as:
Sozo coupling caps
F&T filter caps
Dale mil spec resistors
Switchcraft jacks
Belton sockets
and powered by Classictone transformers
The above 1w is housed in solid Wormy Maple with Sapele face, finished in Danish Oil. It is available for custom order in many different solid woods.
Builders wood choice $849
Custom $899
**Free shipping continental US **Introductory Special
Ask about Worldwide shipping
1 year parts and labor
Lifetime Labor
Customer pays shipping both directions
The Slave Driver is so much more than a 5 watt practice/recording/gigable head. Driven by a 6V6GT and a single 5751 preamp section the Onkel 5w can be used as a 5w practice/recording/live head with passive FX loop. The send can be used as a preamp out allowing you to add vintage tube tone to any amp or you can go directly to the board for live gigs or recording. Line out in rear can be switched between instrument level and line level, and can be used for recording or live gigs. The line out adds the entire circuit post OT and can even be run in a pedal chain. Built in dummy load so no speaker is required for operation. You can even use the 5w power section, the preamp out, and the line out simultaneously. And it's all in a custom solid wood enclosure measuring 12"x 6.5"x 7.5".
-solid state rectifier
-5751 preamp tube
-6V6GT power tube
-passive FX loop
-8 ohm speaker output
-Line out switchable from line level to instrument level
-adjustable/defeatable negative feedback
-bright switch
-Hi and Lo input switch
-Standby switch to protect power tube
Built using quality components such as:
Sozo coupling caps
F&T filter caps
Dale mil spec resistors
Switchcraft jacks
Belton sockets
and powered by Classictone transformers
The above Slave Driver 5w is housed in solid highly figured Poplar, finished in Danish Oil. It is available for custom order in many different solid woods.
Builders wood choice $1049
Custom $1099
**Free shipping continental US **Introductory Special
Ask about Worldwide shipping
1 year parts and labor
Lifetime Labor
Customer pays shipping both directions
Copyright © 2018 Onkel Amplification - All Rights Reserved.
Powered by GoDaddy Website Builder